Structural & Restoration Works in Mumbai
Concrete repair, structural strengthening and facade renewal for ageing and distressed buildings. Atlanta Waterproofing & Protective System carries 7 systems in this category, selected by substrate, exposure and traffic rather than by habit. Each page below states when the system is right and when it is the wrong answer.
7 systems in this category
External Plaster & Painting
CoreExternal plaster and painting is the building's first line of defence against driving rain. Sound, well-bonded plaster sheds water; hollow or cracked plaster holds it against the structure.
IS 2645 · IS 13935
Building Restoration
CoreBuilding restoration is the structural rehabilitation of an ageing or distressed building — diagnosing why the concrete is failing, repairing it properly, and protecting it so it does not fail again. It covers RCC repair to columns, beams and slabs, rebar treatment, carbon-fibre strengthening where sections have lost capacity, facade renewal and full waterproofing.
IS 456 · IS 13935
External Plaster Work
External plaster work removes debonded render and applies new waterproofing-compound-modified cement plaster to the building envelope. Sound plaster is what keeps driving monsoon rain out of the masonry; hollow plaster holds water against the structure and feeds internal damp..
IS 2645
Column & Beam RCC Work
Column and beam RCC work is structural concrete repair to a building's primary frame — cutting out distressed concrete, treating or replacing corroded reinforcement, and rebuilding the section with polymer-modified repair mortar or micro-concrete. It is structural work and must follow a proper diagnosis, not a visual guess..
IS 456 · IS 13935
Carbon Wrapping (RCC Strengthening)
Carbon wrapping bonds carbon-fibre-reinforced polymer fabric to columns, beams or slabs with structural epoxy, adding tensile and confinement capacity without adding meaningful weight or section. It is used where a member must carry more load than it was built for, or has lost capacity to corrosion, and where enlarging the section is not practical..
IS 456 · IS 13935
External Painting
External painting is the final protective and decorative layer on a building envelope. Done properly it follows plaster repair and crack treatment and uses an alkali-resistant primer with an exterior-grade topcoat; done as a cover-up over hollow plaster it fails within a season and hides the actual problem..
IS 2645
ACP Sheet Work
ACP (aluminium composite panel) sheet work installs a rainscreen cladding of aluminium-faced composite panels on a framed subgrid. It gives a building a clean modern facade and a drained, ventilated cavity behind, but it is a rainscreen, not a waterproofing system — the wall behind it still has to be sound..
Structural & Restoration Works on site
@atlantawaterproof ↗
The rest of what we do
- SEC. 01 / COATINGSCoating & Protective Systems
Liquid-applied protective and decorative systems that form a continuous barrier over concrete, masonry and steel.
- SEC. 02 / TRADITIONALTraditional & Specialised Waterproofing
Time-proven Indian terrace systems and high-performance specialist linings, from brick bat coba to polyurea.
- SEC. 03 / MEMBRANEMembrane Waterproofing Systems
Sheet-applied barriers — torch-on bitumen, heat-welded thermoplastic and pre-applied HDPE for below-grade work.
- SEC. 04 / AREAArea-Specific Waterproofing
System selection driven by where the water is: terrace, basement, wet area, tank, podium, lift pit, pool.
- SEC. 05 / GROUTINGLeakage Treatment & Grouting
Remedial injection and joint treatment that stops water already moving through a structure.
- SEC. 06 / FINISHINGFlooring & Finishing
Wearing surfaces and screeds that protect the waterproofing layer beneath and take the traffic.
Frequently asked
How do I choose between the systems in structural & restoration works?
Selection is driven by the substrate, the exposure, the traffic the surface will take, and whether the structure moves. Each system page below states plainly when that system is the right choice and — more usefully — when it is not. If you are unsure, a site inspection settles it in one visit.
Can these systems be combined?
Frequently, yes. Most real buildings need more than one: a terrace system with grouting to stop an active crack first, or a facade coating over repaired plaster. What matters is that the systems are chemically and mechanically compatible with each other and with the substrate.
Do you supply materials, or only apply them?
We supply and apply as a single scope, so responsibility for both material selection and workmanship sits in one place. Where a project specification names a particular manufacturer or product, we work to that specification.
Book the inspection. It costs nothing and it settles the argument.
An engineer visits, finds the actual source, and tells you what the building needs and why. You get a clear scope before any money is discussed.
Mon–Fri 08:00–18:00 · Sat 09:00–16:00 · Jogeshwari West